Mier DA-500 Manual de instalación descargar pdf (Pagina 5)

INSTALLATION page 2 of 2

When more than 1 probe is used, connect the red and black wires in series. Connect

the silver wires in parallel. The red wire from one cable is soldered to a black wire from

another cable. The remaining red wire & black wire are attached to the Drive-Alert

terminals. All silver wires are attached to the Drive-Alert.

Keep the probe, cable, and control panel at least 8 feet away from heavy power lines,

power panels, motors, arcing or sparking machinery, and radio transmitters. In some

cases, moving the panel and/or cable a few feet can solve interference problems.

FIGURE 1 illustrates the contacts on the bottom of the DA-500 Control Panel, with the

sensor correctly attached.

FIGURE 1

The sensing probe is a 1” x 12”

cylinder containing a sealed

sensor. Be cautious when

handling the sensor and

particularly careful to not nick

the cable attached to it.

Bury the probe at least 6” deep.

A typical installation is the probe

6 inches deep parallel to drive,

which will allow the probe to

“sense” 12’ across the driveway.

The ideal installation allows you

to extend your detection

range by installing the sensor

under the center of drive.

12’

RED WIRE

BLACK

SENSOR

SHEILD WIRE

800-473-0213 | [email protected] | www.mierproducts.com

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

Mier DA-500 Manual de instalación Pagina 5